Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Can not add Circuit-Switch integration

During the install of 4.01 one of the new servers did not detect the Dialogic D/120JCT-LS board installed. I reseated the board and during the next attempt to install Unity, it appeared to be recognized. Except now when I run UTIM, the option to create a circuit-switched integration is grayed out.

Is that because of the Dialogic detection problem, or could it be a licensing issue?

1 REPLY
New Member

Re: Can not add Circuit-Switch integration

Uninstalling and reinstalling corrected the problem.

86
Views
0
Helpful
1
Replies
CreatePlease to create content