Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can not enter a location ID Because of Unity Bridge not installed

We can not add Location ID's because Unity is licenced for Bridge but it will not be installed. When Trying to save location ID, prompted to enter Unity bridge ID.

Version 3.1.5

1 REPLY
New Member

Re: Can not enter a location ID Because of Unity Bridge not inst

Yes, no problem there. It will ask you to enter a server address for the Bridge server as well, which you can also enter a 'dummy' address for now. As long as you make sure to set these to the correct values before you actually install the Bridge you should be just fine.

Also note that you may have problems saving changes to this primary location object if the schema has not been extended for the Bridge. If you haven't run the Bridge schema extensions already (just an additional option in AdSchemaSetup.exe) I'd go ahead and do that now.

Hope that helps.

116
Views
0
Helpful
1
Replies