Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

can not ping aim-cue

Any idea why I cannot ping the AIM-CUE ?

thanks

interface Service-Engine0/0

ip address 10.224.32.17 255.255.255.252

service-module ip address 10.224.32.18 255.255.255.252

service-module ip default-gateway 10.224.32.17

!

#ping 10.224.32.18

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.224.32.18, timeout is 2 seconds:

.....

Success rate is 0 percent (0/5)

9 REPLIES
Hall of Fame Super Gold

Re: can not ping aim-cue

Check that module is running, via service-module session.

New Member

Re: can not ping aim-cue

I can make session to module, and also it says up when I check it.

Hall of Fame Super Gold

Re: can not ping aim-cue

When is session, check with the show commands, thta the addresses are right.

Re: can not ping aim-cue

Hi,

Check to have an ip route to the service module ip address with subnet /32 and output interface service engine

thanks & best Regards

Hytham Hadad

Hall of Fame Super Gold

Re: can not ping aim-cue

That should not be necessary, because a dedicated subnet is being used, not unnumbered.

However, I agree that unnumbered using a voice VLAN address is a better choice.

New Member

Re: can not ping aim-cue

I reloaded the module and it is ok now :) interesting...

Hall of Fame Super Gold

Re: can not ping aim-cue

Why you should ?

Either use explicit or unnmbered, as recommended by configuration guides.

Re: can not ping aim-cue

Hi Paolo

thanks for our note

Hall of Fame Super Gold

Re: can not ping aim-cue

You are welcome, please remember to rate useful posts with the scrollbox below.

447
Views
0
Helpful
9
Replies
CreatePlease login to create content