Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Can't call netmeeting from the voice ports

I can't seem to call netmeeting from a 1750 with

voice ports. The other way around works fine. I saw

an answer to something similar early on this list and

it was suggested that firewalling was the problem.

It's not the problem here, because there is no

firewalling between the two points. The netmeeting

phone does make a ring sound but the connection

is immediately terminated. I notice that something

similar occurrs when calling another voice port enabled router when the target router doesn't have a reciprocal dialing target setup for the calling phone.

4 REPLIES
Cisco Employee

Re: Can't call netmeeting from the voice ports

It sounds to me like you have a codec mismatch between the Netmeeting client and the 1750. The reason it works when you call from Netmeeting to the 1750 is that it will accept and correctly handle a call as long as the requested codec is supported by the software.

What codec did you configure on the voip dial-peer on the 1750 pointing to the Netmeeting client? If you have not selected one, try setting one. If bandwidth is not an issue, the best quality is codec g711ulaw on the dial-peer, and on the Netmeeting client, you would go to Audio tab, Advanced, manually set the compression, and choose "CCITT u-Law"

New Member

Re: Can't call netmeeting from the voice ports

Ahh. that did it. I was using the g723ar63 (Annex 1)

version which didn't match. On that note, is there

any significant difference between the standard g723r63 and the annex 1 version?

Cisco Employee

Re: Can't call netmeeting from the voice ports

Um, I'm not sure about that. You'd have to read the G.723.1 standards in the ITU specs. There are probably at least some slight differences but I do not know what they are.

New Member

Re: Can't call netmeeting from the voice ports

I don't think that CM/IP Phones support G.723 w/o transcoding (h/w needed). Has anyone found a G.729a codec for Windows/NM that will work w/ CM and IP Phones?

135
Views
0
Helpful
4
Replies
CreatePlease to create content