Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Can't change mailbox_store in DOHPropTest

We are putting up a new exchange server and need to move our unity1 box to the new server. I went through the instructions that Jeff Lindborg put up a while ago. I can do everything except change the mailbox store in the DOHPropTest utility, any ideas?

Here is the link I used:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.eea3f6b/2#selected_message

This is the error code I get:

error: 0x80072030

Thanks,

Geoff

3 REPLIES
Cisco Employee

Re: Can't change mailbox_store in DOHPropTest

Well, what version of Unity is this? Can't really do much of anything without that data...

There's a much nicer reconfiguration guide that's recently been published here:

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps2237/products_installation_and_configuration_guide_book09186a00802059b3.html

it contains instructions for doing just this for 4.x servers.

Bronze

Re: Can't change mailbox_store in DOHPropTest

Sorry that would have been good, huh! It is 3.1(4). I am going to 4.x later this spring, but will be staying on this version for now.

The link is a partner link? I can't access it.

Thanks,

Geoff

Cisco Employee

Re: Can't change mailbox_store in DOHPropTest

Try this link:

http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_installation_and_configuration_guide_book09186a00802059b3.html

when accessing the sites behind the Cisco firewall it always sticks the "partner" qualifier in there - I gotta remember to take it out when posting links.

the document is for 4.0(x) systems - it wont apply back to 3.1(4) I'm afraid...

133
Views
0
Helpful
3
Replies
CreatePlease to create content