Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can't transfer to an analog phone on FXS port (CME2811)

I have six IP phones with locals 501 to 506. Additionally, I have four analog phones (locals 541 to 544) connected to a VIC2-4FXS card on a 2811 with CME and CUE module.

All phones can call each other. But if say, a user on an IP phone calls a 2nd user on another IP phone, the 2nd user cannot transfer to the 54x locals. She hears a busy or reorder tone (still need to verify which) after keying in the 2nd digit (ie. 54 then "busy" tone)

Am I missing something?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Can't transfer to an analog phone on FXS port (CME2811)

Under telephony-service configuration enter the transfer-pattern command. For example:

router(config)#telephony-service

router(config)#transfer-pattern 5..

If no transfer pattern is set, transfers are only permitted to other IP phones.

Hope this helps. If so, please rate the post.

Brandon

2 REPLIES

Re: Can't transfer to an analog phone on FXS port (CME2811)

Under telephony-service configuration enter the transfer-pattern command. For example:

router(config)#telephony-service

router(config)#transfer-pattern 5..

If no transfer pattern is set, transfers are only permitted to other IP phones.

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: Can't transfer to an analog phone on FXS port (CME2811)

Right on the money. Thank you.

122
Views
5
Helpful
2
Replies
CreatePlease login to create content