Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can the module VIC-2BRI-NT/TE play NT and ST role ?

cna I configure the module VIC-2BRI-NT/TE to be able :

1) to connect an ISND phone or PBX (NT mode)

2) to configure it as ST (connect it to the network

2 REPLIES
New Member

Re: Can the module VIC-2BRI-NT/TE play NT and ST role ?

no problem,

we already connected the following equipment, an GSMBOX (1760 TE mode) ; fax server card (1760 NT mode).

You will have to use the H323 to implement the dial-peers, ...

Greetings

Dirk

Silver

Re: Can the module VIC-2BRI-NT/TE play NT and ST role ?

Officially the NT mode does not support direct connection of ISDN handsets as it only can handle 1 TEI (no provision for SBus) but if the ISDN handset works then good luck. You should not have any problems with the PBX in NT mode or direct connection to the ISDN when running in ST mode. Refer here for more information -

http://www.cisco.com/warp/public/788/signalling/bri_voice_port_cfg.html

118
Views
0
Helpful
2
Replies