Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot access Cisco ATA186 Web page setup

I have the ATA186-L1. According to the manual I should be able to configure it through its IP address. I type in http://<ip adress>/dev

The page will not come up. I did try http://<ip adress>/reset. That came up with "ok." and a blue screen.

I have even tried the voice prompt reset, still i cannot access the web setup page.

The software is version 2.16.

Thanks for any help!

2 REPLIES
Anonymous
N/A

Re: Cannot access Cisco ATA186 Web page setup

This is how you reset the ATA186 back to default settings:

1. Unplug the ethernet cable.

2. Pick up the telephone handset

3. Press the function button on top of the ATA

4. Enter 322873738#* (Reset box configuration)

5. Hang-up

6. Pick up the telephone handset

7. Press the function button on top of the ATA

8. Enter 305# (Disables the use of TFTP)

9. When prompted to enter a value, enter 0#

10. When prompted with the option to save, enter 3.

11. Hang-up

12. Reconnect the ethernet cable

13. Try accessing the web page

New Member

Re: Cannot access Cisco ATA186 Web page setup

Thank you for the reply.

I followed the directions in order.

It did not work.

Upon pressing the# key on step 4 the ATA responded with "CAFFWD."

I still followed the steps.and step 8 I got the same response.

And still no access to web setup..

I know the thing works fine. I was using it not to long ago with another service.

Thanks.

519
Views
0
Helpful
2
Replies
CreatePlease login to create content