I have a LAN2LAN VPN between a PIX 501 and 3030. I want to be able to connect a phone at the remote site. The tunnel is up and I can ping the phone but it doesn't connect to the CM. Is there something I have to configure on the PIX to allow the phone to connect?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.