Problem: Get an IE error "Unknown error occured.. Subscriber could not be created." when I try adding subscribers via unity. <br>Note: I can add users to the domain using the same SA account via UserManager, I can create Exchange Accounts and assign them an NT account(Create/Choose a Existing Account)with same SA account. <br>I can import users from exchange to create a new subscriber.<br><br>Unity Ent. Rev. 188.8.131.52 <br><br>Thanks - V<br><br><br>
The Unknown Error message usually means the NT or Exchange account creation failed from underneath us for some reason. Were working on getting better logging in place to try and pull better messages than unknown, which I know isnt too helpful many times we dont get much back other than a generic failure code, however.
One of the things thats caused this in the field from time to time would be if the minimum NT password length is, say, 6 and the default NT password on the subscriber template your using to create this person is 12345. The NT account creation fails in this case and youll get that.
Another possibility is a conflict with an existing Exchange account alias or something along those lines. This is a problem for sites that dont have matching NT and Exchange aliases (which is rare, but happens).
Also, be sure that you have Domain Admin rights we WILL let you install without these rights and if the account you used to install doesnt have it, youll see the same thing here. If youre logged in as that account doing your testing, that wouldnt be it since it sounds like you can create users in NT/Exchange OK double check which account is associated with the AVCSxxx services in the SCM just to be sure.
Beyond that, Id have to direct you to call our support folks and we can get into your system and investigate.
We tracked the SA creation problem down to a situation where a public distribution list referenced in the subscriber template being used to create users got too many users in it, the SA was taking too long to check and see if the new user was already a member or not and it would time out, failing to create the user. This has been fixed in the upcoming 2.4.6 release and you can work around it now by removing any PDLs from the subscriber template you're using.
There's also a known problem with the stand alone import utility (not the SA) where adding users using a template that has no PDLs associated with it throws and exception (anyone want to comment on the irony here?). This has also been fixed in 2.4.6.
If you're having a different problem than either of those two, be sure to contact our support folks and get a ticket open since we don't know about it at this point.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.