I have set up redundant callmanagers with a couple of 7960 IP Phones and ATA186s. I cannot seem to call from the 7960s, but I can call from the ATA186s. I get a fast busy. I can even call the 7960s from the ATA186s, but not the other way around. The configs seem to be the same as all the other times that I have configured callmanagers. The only difference is this time I'm using 3.13a instead of 3.12c. Maybe I'm missing something obvious. Any ideas would be helpful.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...