We got CCM 3.2 running CAR. The reports work fine etc, but when I tried to setup the e-mail function, ie e-mail reports and/or errors to a certain mail box the systems comes back and gives me the following message :
I have double check that our Exchange 5.5 server is setup correctly, ie it has the mailbox setup that I specified, right password etc etc. Does anyone what this error means and how to I fix? Is there any doco on how to setup a MS Exchange 5.5 server for this?
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.