CCM 3.3.3. I have the same issue as another conversation on the Forum about the CAR QOS report always showing NA in the QOS Orig. and Dest. fields. I have researched the CAR documentation and have made sure that my QOS parameters are configured and make sence. I even added a separate parameter for Latency and adjusted it all over the map from 0-50, 51-100, 101-150, 151-200, etc. trying to get the report to show something, but it never does. I have also adjusted the other parameters trying to get useful results. I need to use the report to justify call quality issues over the WAN, but a report with NA in it is useless. Has anyone been able to adjust the QOS parameters and get results other than NA? I can't believe that at least one of the calls in the network does not match at least one of the QOS parameters configured.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4