Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAS bits manipulation

Hi,

I need to connect a 3620 with a NM-1FE1CE1B module to a Siemens HiCom 300 Series PBX. The use of the 3620 router is as a RAS. My questions are:

- Is there a way to individually manipulate the ABCD bits of the CAS signalling?

- What combination of ABCD bits correspond to each country setting?.

- Which is the recommended type of signalling for the ds0-group provided the PBX supports all types?.

Thank you very much in advance,

Best Regards,

VS

1 REPLY
Cisco Employee

Re: CAS bits manipulation

I don't think the NM-1FECE1B supports CAS signalling. Is this going to Be a T1 between the GW and the PBX? If so, you will need to use an NM-HDV-T124.

With the HDV card, yes we can make the CAS bits whatever we want. Under the voice port, you can use the define-tx-bits and define-rx-bits commands to define what you want for idle ans seize patterns.

CAS bits are not assigned by the country setting unless you have an E1 doing R2 signaling. I would use E&M wink unless the PBX supports PRI, then I would use PRI and get rid of the whole CAS part.

159
Views
0
Helpful
1
Replies