Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CAS T1 Passing ANI MGCP

Greetings,

I am trying to get ANI to pass from a gateway to CRS apps. Configuration is CCM 4.1(3)sr2, 2821 w/2port MFT doing MGCP IOS 12.3-14T5.

I looked at URL http://www.cisco.com/en/US/products/sw/iosswrel/ps1834/products_feature_guide09186a008007fe27.html#17692 as a possible option, but my gateway doesn't support e&m-fgb.

I also looked at http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_configuration_guide_chapter09186a008020ecf6.html#wp1042209 but when I tried to use e&m-fgd, I received either silence or dialtone and direct-inward-dial didn't help.

Any suggestions would greatly be appriciated.

Best Regards,

Craig

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CAS T1 Passing ANI MGCP

In order to receive ANI on a T1 CAS circuit you need to use "type e&m-fgd" on the 2821. Unfortunately, fgd isn't supported with MGCP and CallManager.

2 REPLIES
Cisco Employee

Re: CAS T1 Passing ANI MGCP

In order to receive ANI on a T1 CAS circuit you need to use "type e&m-fgd" on the 2821. Unfortunately, fgd isn't supported with MGCP and CallManager.

New Member

Re: CAS T1 Passing ANI MGCP

You will have to configure the router as H.323 to support caller id on a T-1.

163
Views
0
Helpful
2
Replies