Re: catalyst dsp resources for conferencing and transcoding
Also make sure that the port is configured correctly on the Callmanager.
Here is an excerpt from a Cisco link on troubleshooting the 6608 blade
Another common problem is that the port is not configured correctly on the Cisco CallManager host. A typical error is incorrectly entering the MAC address of the elvis. If this is the case, you will probably continuously get the following on the NMP console every two minutes:
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.