Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cause i = 0x8283 - No route to destination

I have a really weird problem, im trying to sell minutes by voip on my 7206vxr.

E1 to E1 works fine, but when i try to terminate traffic on my box from voip i get the message:

ISDN Se1/1:15 Q931: TX -> SETUP pd = 8 callref = 0x4BE4

1584253: <009>Sending Complete

1584254: <009>Bearer Capability i = 0x9090A3

1584255: <009><009>Standard = CCITT

1584256: <009><009>Transer Capability = 3.1kHz Audio

1584257: <009><009>Transfer Mode = Circuit

1584258: <009><009>Transfer Rate = 64 kbit/s

1584259: <009>Channel ID i = 0xA1839A

1584260: <009><009>Preferred, Channel 26

1584261: <009>Progress Ind i = 0x8A83 - Origination address is non-ISDN

1584262: <009>Calling Party Number i = 0x00C3

1584263: <009><009>Plan:Unknown, Type:Unknown

1584264: <009>Called Party Number i = 0x91, '0044(removed uk local number)'

1584265: <009><009>Plan:ISDN, Type:International

ISDN Se1/1:15 Q931: RX <- DISCONNECT pd = 8 callref = 0xCBE4

1584349: <009>Cause i = 0x8283 - No route to destination

1584350: <009>Progress Ind i = 0x8288 - In-band info or appropriate now available

1584351: Dec 1 14:36:21.605 gmt: ISDN Se1/1:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x4BE4

1584352: <009>Cause i = 0x80AF - Resource unavailable, unspecified

Ive removed the rest of the uk 0044 number for obvious reasons.

But why is the switch returning Cause i = 0x8283 - No route to destination, when it is a working telephone number.

  • Other Collaboration Voice and Video Subjects
1 REPLY
New Member

Re: Cause i = 0x8283 - No route to destination

If this is in UK, why are you sending calls to the PSTN starting with the international prefix ?

Shouldn't that be left out leaving only the local number ?

1604
Views
0
Helpful
1
Replies