05-10-2002 11:35 AM - edited 03-12-2019 06:46 PM
Pri-Qsig VOFR or VOIP
Where can I find some real answers with regards to Pri-Qsig signaling and switching.
Why does it fall apart I have tried everything can someone help.
Sometimes it work perfectly, other times even during low traffic periods it just does not work.
Reset controller sometimes it comes back
After a reload it comes back
Longest up time so far 1 week.
Is there a go way to insure your dial-peer are configured properly.
How can I tell if there is a problem?
debugs ? it is a lot of information what is what. Memory? IOS?
05-11-2002 06:06 AM
Pri-Qsig VOFR or VOIP
The problem is when fifteen channel are active at the telephone central
voice communication are normal.but when request 16-17----etc. channels
we are not able to call from router.
05-19-2002 07:24 PM
Hi Tim,
We would need the results for debug ISDN q931 when a call fails.
May be best to open a TAC case on this issue.
06-23-2002 07:59 PM
Tim,
There is some very good information on one way voice issues and troubleshooting one way voice problems , very much like you discribed on the TAC website. I would probably start there. Without looking at your configs and understanding your issues this would be quite difficult to diagnose from the information you have given.
Hope this helps
Alan Basing CCIE 7145
10-08-2002 11:03 AM
Tim, How did you make out with your problems? I'm trying to network my PBXs over IP, using QSIG. Are you still experiencing one way speech?
Sorin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: