Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

CCM 3.1(3a) and a 1760 16 port FXO

What version CCM can I configure a 1760 16 ports FXO gateway on?

I would like to configure a 1760 with four 4port FXO cards. Each 4 port card must be able to be divided into two separate FXO H323 gateways on each 4 port card.

In other words I would like to get 8 different H323 gateways on the 1760, each gateway using/alternating between 2 FXO ports.

Is this even possible to do?

Thanks

Rob

1 REPLY
Silver

Re: CCM 3.1(3a) and a 1760 16 port FXO

From the CCM's perspective, the 1760 would behave as a single H.323 gateway only. However, if your intention is to have select numbers for a set of

fxo ports, create one route-pattern for each set of fxo port and configure the dial-peers in the 1760 appropriately to handle this.

Another option is to use DNS. Have 8 DNS entries for the same 1760 and use the above mentioned dial-peer configurations. CCM 3.1(3a) that you have is fine for the above solutions.

91
Views
0
Helpful
1
Replies
CreatePlease to create content