we have a CCM 3.1 server running MOH, I have added the music on hold stream on the server, when we call in and are put on hold we hear the stream ok, however, I would like to try and configure the stream to play continuously, so it does not just begin at the start every time a call is placed on hold, I would like the 4 minutes worth of messages/music to continually play and calls placed on hold would hear randomly different parts of the stream at different times when they call rather than the start of the message every time they are placed on hold.
Can this be configured or is there a work-around for this?
Thanks in advance for any advice you can provide on this subject.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...