I need to install CRA on a lab box that I want to be a publisher. I do not/cannot easily get the key code to reinstall CRA. My thinking was to take a drive from a subscriber that has CRA installed on it, put it in my lab machine and boot from that drive, then make that box the publisher.
Customer has a Publisher and a Subscriber but does not have any RAID capability on either server. There is a problem on the publisher that causes the harddrive to fail hard. Currently the only way around this is to completely rebuild the publisher from scratch, hope that their backups are up to date. It would have been far easier to have been able to promote the Subscriber to be the Publisher, it already has the database, and then rebuild the failed system as a Subscriber.
This has happened to a couple of customers with the most painfull one where they had the 7750 server blade as the publisher and a MCS7825 as the Subscriber.
This option should be one of our tools for emergency repair of a IPT network.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...