Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CCM 3.3.2c Inter-Cluster Trunk CallerID = Private

I have two CM 3.3.2c clusters connected with an Inter-Cluster Trunk (non-GK). It works fine except that from one side to the other, the incoming CLID is displayed as Private for some (not all) callers. In the other direction, it works fine. Each 7960 has 2 line appearances. Calls made from the first show as Private; from the second, the CLID is correct. The outgoing transform mask sets the outgoing CLID to 408555XXXX. The trunk is set to all defaults.

Any suggestions how to find where the problem might be?

  • Other Collaboration Voice and Video Subjects
2 REPLIES
New Member

Re: CCM 3.3.2c Inter-Cluster Trunk CallerID = Private

Enable the Display IE Delivery checkbox under the gateway configuration.

New Member

Re: CCM 3.3.2c Inter-Cluster Trunk CallerID = Private

Display IE Delivery is already checked on both ends of the Trunk.

Redirecting Number IE Delivery is also checked for both IN & Outbound on both ends.

(Outbound) CallerID DN is blank on outbound.

120
Views
0
Helpful
2
Replies
This widget could not be displayed.