Has anyone integrated a legacy iSDX running 7.1 software with CCM 3.3x or 4.0 via E1 QSIG or Q.931 rather than DPNSS? I'm trying to deliver the same functionality as the DPNSS (CLI, DDI, MWI, Voice Mail, call forward) without utilising expensive Westtel or Checkmate gateways.
We are running CCM (3.3.3 now but have run 3.0.9, 3.1.3, 3.1.4 and 3.3.2) with an iSDX-s that runs 7.1 software. We use the iSDX to provide DDI numbers for 50 users on the CCM side. We can call forward transfer, etc. from iSDX to CCM and from CCM to iSDX.
We run an e1 card and use a q.931 trunk from the DLI card in the iSDX into the back of a 2611 router. We do loose some functionality though. We have no CLI passed through, and use unity for UM on CCM but a seperate VM for iSDX.
If you want some more info off line then drop me a mail.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...