Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

CCM 4.1(3) multiply T1s, PRI, routing with CMM card

I have the following hooked up and working currently:

CCM 4.1(3)

(2) CMM blades in 6509

(4) PRIs (2 in each CMM blade)

(1) Tie line gateway for remote office connections

My client wants to add (2) T1 lines into the CMM and route only long distance calls on this for outbound. Other offices have the same provider at their end so it stays on the providers circuits and cheaper LD rates.

To force Site A with CCM and CMM to have all LD calls route outbound, do I need to setup a route pattern for LD and local?

Local would be 715 and 920, all others would be LD.

Local 91715xxxxxxx use the PRI

91920xxxxxxx use the PRI

LD 91??????????? use the dedicated circuit xyz

Do I need to list out all the patterns for this to seperate my route pattens for each gateway or is their an easier way?

Thanks much

2 REPLIES
New Member

Re: CCM 4.1(3) multiply T1s, PRI, routing with CMM card

I think you need to configure a list of route patterns/route lists to select the appropriate gateways

Blue

Re: CCM 4.1(3) multiply T1s, PRI, routing with CMM card

what you should do is define a CSS and partitions for each site.

then you define routePatterns for each site, using the site specific partitions.

this way, you'll be able to direct siteA LD calls out a specific PRI while allowing other sites to use other gateways for their LD calls.

if you need an example, let me know and i'll type one up! :)

NOTE: with this type of heirarchy, you will have multiple routePatterns of the same digits.

ie:

91xxxxxxxxxx - PT_SiteA

91xxxxxxxxxx - PT_SiteB

201
Views
8
Helpful
2
Replies