Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CCM 4.1(3)sr2 and MGCP Gateway C2621-XM

Hi.

I have a Cisco 2621XM with a NM-HDV2-1T1/E1 configured on the CallManager as a MGCP gateway. The MGCP gateway T1/PRI endpoint shows up on the correct slot 1/0. That is the onboard T1 port within the NM. Now I would like to add another VWIC-1MFT-T1 to the VIC available on the NM-HDV2 card but when I add that on CallManager it also shows up at 1/0.

Any ideas? If I add a VIC2-4FXO on the CCM web page it add the ports as 1/0/0-1/0/3.

Thanks in advanced,

-Jose

4 REPLIES
Community Member

Re: CCM 4.1(3)sr2 and MGCP Gateway C2621-XM

Copy paste the show diag from 2621xm

Re: CCM 4.1(3)sr2 and MGCP Gateway C2621-XM

Check this screenshot. Change the begin port to 1 for the vic slot on the nm-hdv2.

Sankar

PS: please remember to rate all posts!

Community Member

Re: CCM 4.1(3)sr2 and MGCP Gateway C2621-XM

I will try that when I get a chance. I haven't insert the VWIC yet on the router so I don't know if the router will put it on 1/1 or on 1/0/0.

I'll let you know..

Thanks,

-Jose

Community Member

Re: CCM 4.1(3)sr2 and MGCP Gateway C2621-XM

attach sh tech from the router 2621xm....

159
Views
0
Helpful
4
Replies
CreatePlease to create content