I have a CallManager 4.1(3) install which has a QSIG integration with a Siemens HiPath 4000 Release 2 via E1 on a CMM. MGCP is the protocol being used and the VM being used is Siemens Xpressions.
Everything is working fine. If there is an VM on the Cisco Phone the MWI turns on. The only problem that we have is the Call back feature. If i like to activate a call back from a Cisco to Cisco or Cisco to Siemens phone the call back function works but without activating the lamp on the phone to signal a call back. I need to be able to send MWI Activate and Deactivate messages to the Siemens phones and to Cisco phones by activating a call back.
Is there someone in this forum that can help me get this working?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.