Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ccm 4.1 connected to ccme 3.4

i have a CCM 4.1 connected through the ccme through route pattern and h323 gateway both ccm and ccme is connected through tunnel. i can make call and receive calls .the problem what i am facing is if i dial the number from ccm to ccme the caller wont get any ring tone. but the ccme user will get the ring tone . but if the ccme user dial our ccm number we both can hear the ring tone.what could be the problem? how i can solve this ring tone issue kindly send your valubale reply .

2 REPLIES
Green

Re: ccm 4.1 connected to ccme 3.4

Instead of H323 GW, use an ICT...non-gatekeeper controlled. Make sure MTP is enabled.

Green
112
Views
3
Helpful
2
Replies
CreatePlease to create content