Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CCM 4.1 re-home

Hi,

We have 2 CCM 4.1(3)SR1 servers part of a single cluster.All the phones are registered to Subscriber.

Recently we had rebooted the subscriber.

All the phones re-homed to publisher during the reboot.Most of them re-homed to Sub once it was up.

But some of the phones are still registered to Publisher but gets registerd to subscriber once we reset.

Why are they not getting re-homed automatically??

Few of these(which are still registered to Pub) give an error "Host not found" when service button is pressed.when we reset these phones these get registered to Subscriber & service button works fine.

What could be the problem??

Regds

Kiran

2 REPLIES

Re: CCM 4.1 re-home

Kiran,

Under System - > Callmanager , are the CM servers set names or IP address ?

New Member

Re: CCM 4.1 re-home

Hi Kiran,

First of all make sure that you are using IP addresses instead of hostnames for the Callmanagers - it is recommended by Cisco. If you havent done that, in that case make sure that the hosts and lmhost file on the Publisher and Subscriber is updated with proper IP entries. That should make things work properly.

Let me know how things go.

98
Views
0
Helpful
2
Replies