i've migrated my CCM 4.1(3) to 4.2(1). It seem to work good except for the IPMA. The CTI RP is not registered, the service on the phone tells initializing and it is not working all. Any experience on this?
Is the IPMA service started? I would re-activate it, and also reset the Tomcat service. I know there have been some changes to IPMA on 4.2 such as available phone service for the assistant, but it should not chnage the operation of it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...