I have a 3845 gateway andI am trying to turn up an E&M / CAS T1. There are currently 6 other PRI T1s on this gateway that are fully functional, so I have good confidence in my MGCP setup. I have 24 ports defined in CCM and the gateway shows 24 voice ports DORM IDLE ILDE.
When I try to reset the T1 via CCM, all T1s in that gateway are reset (ouch!) This doesn't happen with my PRI T1s - are CAS different this way?
Any input, advice or assistance would be appreciated.
Turns out that the first time a port is defined, you need to restart MGCP by doing a "No MGCP", "MGCP". Unless you do this, it seems that all ports on the gateway are reset when you attempt to reste the non-registered port.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.