Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM 4.x | SIP TRUNK

Hi.

The CCM 4.x works with SIP TRUNK?

The CCM 6.0 is Windows or Linux?

Thanks

4 REPLIES
Hall of Fame Super Red

Re: CCM 4.x | SIP TRUNK

Hi Peterson,

Here is the info you were looking for;

SIP Signaling/Trunk Interface Configuration Checklist (***CCM 4.1(3))

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edb28.html#wp1126527

Cisco offers two versions of Cisco Unified Communications Manager: Version 4.X on the Windows 2000 Operating System, and versions 5.X and ***6.0 as a Linux-based appliance model implementation.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/product_solution_overview0900aecd805e19e7.html

Hope this helps!

Rob

New Member

Re: CCM 4.x | SIP TRUNK

Ok.

So i need a sip proxy server.

I would like interconnect a PBX Siemens and CCM 4.x by SIP Trunk, but in the picture and document see that's need a SIP Proxy Server "in-the-middle".

Another question, in SIP Protocol, I can use a gateway like i use in MGCP? Redirecting call, controlling ports, etc, management by CCM?

Thanks

Re: CCM 4.x | SIP TRUNK

You do not need a SIP proxy server.

The CCM 4.x support SIP trunks (what it does not support is SIP endpoints).

A SIP trunk is where you directly send an INVITE message, without the need to REGISTER.

The Siemens HiPath 2030 are able to handle SIP trunks as well, if my memory serves me correctly.

New Member

Re: CCM 4.x | SIP TRUNK

297
Views
0
Helpful
4
Replies
CreatePlease login to create content