guys i have setup CCM6 on VMWARE and now at login page i put the th elogin (which i put whil einstalling the CCM 6) but its not taking it keep on saying invalid....which is really pissed me off as i built another server and it the sam eproblem can someone plz tell m ehwta th ehell is going on.....secondly is there any other username or password i can use as thgis thing ismaking me crazy????? very disappointed with it....help i needed
My friend thanks for your reply.....i know how to use the doc....on cisco website i have alreadyu seen this doco.....that is the probl;em that its not getting th epassword which i set whil einstalling CCM 6....thats why i get frustrated......i even used ccmadministrator as well............but it says invalid login???? cheers
I had the same issue until I logged into the CLI and used the "utils reset_ui_administrator_password" command and typed the password real slow and made sure they matched. After doing that I was able to login using CCMAdministrator and the new password that I entered.
At the console of your VMware session, login in CLI as the OS administrator (you should have created this account during installation). Once you are logged in then run the "utils reset_ui_administrator_password " command and it should prompt you to enter a new password and also to confirm it. When you type it in make sure you type it slowly because there is now feedback to what you are typing and I have noticed that sometime it will drop or double charters when typing in the console. Once you have done that you should be able to login using CCMAdministrator and the new password that you have entered. There is also a command to change the UI account name as well.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.