CCM being able to pass caller ID (just number) through tapi?
Right now caller's numbers show up on our hardphones, but CCM doesn't seem to be passing this info over tapi. I have the TSP drivers installed, and have installed an application that is supposed to take the incoming calls and pass info into another program, but all the calls show up as "unknown". I tried a few different ones, and they were all the same result.
My thinking is that the correct info is being sent through tapi/the tsp drivers. Anyone tried to do this, or know what might be going on?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...