08-01-2002 04:33 AM - edited 03-12-2019 08:10 PM
When i choose inside region codec g729 on CCM then I see on gw (show call active voice brief ) codec type g729br8.
Is possible to change codec from ccm to gw to g729r8 and not to g729br8?
Thanks
Martin
08-01-2002 10:33 AM
I think the phones will do g729br8. All versions of g729 are suppose to work with each other.
Thank you,
-Mckee
08-02-2002 12:18 AM
Codec g729br8 has in-build VAD. If I set no Vad on gw dial-peer, there is still
vad enabled during active call. On CM is Vad disabled.
That is why i wanted to change codec to g729r8.
Martin
08-02-2002 03:11 AM
you can do this with "voice class codec "
for example :
voice class codec 1
codec preference 1 g729r8
codec preference 2 g729br8
on the voip dial-peer you have to insert the:
voice class codec 1
perhabs also:
incoming-called number ..
hope this helps
regards
mehmet
08-02-2002 04:06 AM
Mehmet i have just tried it, but it does not work. I have configured it in the way
you described, but there is still codec g729br8 on gateway (show call active voice brie).
Thank you
Martin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: