Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

CCM intergrate with CME!!!

CMM 4.13sr3c and CME3.3

I am not using hardware gatekeeper at all.

At CCM, I created Trunk(not gatekeeper controlled), and route group, list and pattern. I can make a call to CME's phone without any problem.

At CME:

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g729r8

!

!

voice class h323 1

h225 timeout tcp establish 3

!

dial-peer voice 1000 voip

destination-pattern [12]...

voice-class codec 1

voice-class h323 1

session target ipv4:10.0.0.21 (Sub)

dtmf-relay h245-alphanumeric

!

dial-peer voice 1001 voip

preference 1

destination-pattern [12]...

voice-class codec 1

voice-class h323 1

session target ipv4:10.0.0.20 (Pub)

dtmf-relay h245-alphanumeric

I could not call from CME to CCM, I got fast busy.

Thanks for help.

Ken

4 REPLIES

Re: CCM intergrate with CME!!!

I would check if the phones in CCM you are calling is in a partition, then the Trunk in CM should have a Inbound call CSS set with access to that partition.

HTH

Sankar.

PS: please remember to rate posts!

Bronze

Re: CCM intergrate with CME!!!

Shanky,

Partition and CSS are in the right place...

Anyone help??

Ken

Re: CCM intergrate with CME!!!

Do you ahve a dialplan pattern ? Can you paste your Telephony-service config ? Also please post a "debug voip ccapi inout" output.

Bronze

Re: CCM intergrate with CME!!!

I forgot to put this command under interface:

h323-gateway voip bind srcaddr x.x.x.x

Thanks for help guys.

KEn

121
Views
0
Helpful
4
Replies