The server when inspected around 6.30pm it was at the prompt (Non system Disk Error). There was no floppy diskette inside.
The Engineer recycled the power and when the system booted the IP phones were not able to register. On further inspection it was observed that the CISCO RIS data collector service was in stopping mode.
It got resolved after rebooting again. After checking the event viewer there was an unexpected shutdown of the server at 11.30 pm yesterday. During that period there was 1 error with ID 1281 related to NIC Agent and CTI agent hung during startup error with event ID 7022.
The RIS Data Collector has a lot of problems starting usually if the NIC is not functioning properly . There are a lot of problems with BAD NICS that I know of that can cause the RIS Data Collector not to start. It is worth giving a check on the NIC
What are the DCOM error thats you get on the server.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...