CCM Trouble dialing international number from Outlook Contacts
I have a customer here in US with their parent company in Germany. Call Manager 3.3.3. They are using the Call Manager TSP to dial from Outlook Contacts. Calls within the US are dialed fine but when they try to dial an international number the number never gets dialed, the phone goes off hook but the dialed number is never diasplayed on the phone. In looking at the TSP trace I do not see a calledpartynumber in the trace. The number is entered into outlook contacts as +44 123 12345 and the outlook dial properties show the correct number to be dialed, 9 011 44 12312345, Any thoughts would be appreciated.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...