Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM Upgrade issues for 3.1.2 to the latest

I am looking at upgrading our site to CCM3.2.1 soon. We have a need for the auto-answer speakerphone feature, the ATA-186, and a few other devices that cannot be used under 3.1.2. Any and all feedback would be greatly appreciated. We are using IOS gateway w/ NM-HDV's and PA-VXA-1TE1-24+ w/ PRI lines for PSTN connectivity. Our phones are a mix of 7960,7940,7935, and 7910. We have two CM's w/ approximately 600 phones at the moment and will be expanding to about 800 phones in the next two months. We are also running Unity 2.4.6. w/unified licenses. Thanks in advance for your input.

4 REPLIES
Cisco Employee

Re: CCM Upgrade issues for 3.1.2 to the latest

I would go ahead and go to 3.2(2a). I don't even see 3.2(1) on the downloads page anymore.

Thank you,

-Mckee

New Member

Re: CCM Upgrade issues for 3.1.2 to the latest

Thanks for your input.

New Member

Re: CCM Upgrade issues for 3.1.2 to the latest

Just finished upgrading to 3.2(2a).

The ATA-186 will work with 3.1.2. I just wanted to mention this as the main reason I upgraded was I thought I had to to utilize the ATA186. You need to add it in as a 7960 use the MAC from the ATA186. Add a second 7960 for the second port and use the MAC of the ata but lose the first two numbers and append 01 to the end.(e.g 7960 port 1 = 00070edcd10d, 7960 port 2 = 070edcd10d01)

In regards to 3.2(2a)

Make sure and reinstall the JTAPI client with the new version from 3.2. Had some problems with the ATA186 and 3.2. The SCCP/MGCP code for the ATA186 posted on CCO(2.14ms) has a bug that causes the ATA186 to lose connection with the CM periodically. This will be fixed in the next release but this does not come out until sometime in July. If you plan on using 3.2 before then I can e-mail you the 2.12ms code for the ATA186 if your are planning a SCCP/MGCP implementation. The auto-answer feature worked great and I have to say that the upgrade went very smooth. Good Luck.

New Member

Re: CCM Upgrade issues for 3.1.2 to the latest

Thanks for the info..... please feel free to e-mail me the code. It would be greatly appreciated. My e-mail is michaellebron@richlandonline.com

Thanks in advance,

-mgl

120
Views
0
Helpful
4
Replies
CreatePlease login to create content