Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CCM - voip gateway - PBX Integration

CCM ver3.3 is configured by using router-patterns and H.323 gateway configurations so that I can initiate a call from IP Phones through gateways (then ended at a PBX subscriber). However, the other way around does not work.

CCM: 10.81.50.2

IP Phone: 10.81.50.11

1st button on 7640: 3302

2nd button on 7640: 3304

Cisco 3640 H.323 gateway: 10.81.3.161

PBX is connected to Cisco 3640 via PRI trunk, HDV..

If it was initiated from IP Phones, call is established. Else if, call is droped if it is initiated from PBX.

Configurations are as follows:

IP Phone button 1: 3302

IP Phone button 2: 3304

CCM:

Route-pattern configs..

If 3XXX then forward to G/W:10.81.3.161 with a prefix 2

If XXXX then forward to G/W:10.81.3.161 with a prefix 2

Router 3640:

!

voice class codec 1

codec preference 1 g729r8

codec preference 2 g729br8

codec preference 3 g711ulaw

codec preference 4 g711alaw

!

!

interface Serial1/0:15

no ip address

no ip route-cache cef

no logging event link-status

no snmp trap link-status

isdn switch-type primary-qsig

isdn incoming-voice voice

isdn disconnect-cause 3

no cdp enable

!

!

voice-port 1/0:15

input gain -4

output attenuation 4

cptone TR

!

!

dial-peer voice 30 pots

destination-pattern 2....

direct-inward-dial

port 1/0:15

!

!

dial-peer voice 21 voip

destination-pattern 3302

voice-class codec 1

session target ipv4:10.81.50.2

ip precedence 5

!

Returned disc cause was: 3 "no route to destination".

Evenif I removed 3XXX and XXXX routes from the route-pattern list, same disc. cause returned from CCM to router.

Thanks for aid,

Onur

1 REPLY
Cisco Employee

Re: CCM - voip gateway - PBX Integration

This forum is for Unity, Cisco's Unified Messaging product. You might want to try the IP telephpny forum, if you don't get any answers here.

120
Views
0
Helpful
1
Replies
CreatePlease to create content