Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CCME 3.4 unable to transcode

I have a 7940 registered via SIP to a 2621XM running 124-4.T in CME mode. I have codec G729r8 specified in my out going voip dial peer but the router won't trancode between G711 and G729. It used to work when I had the 7940 using sccp.

1 REPLY
New Member

Re: CCME 3.4 unable to transcode

There are updated SIP files available - you could try those (due to CCME 4.0)

V4.0 supports transcoding SCCP phones and 729r8 on CCME phones now. It works too... ;)

p.

93
Views
0
Helpful
1
Replies