Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CCME 4.0 number of conference calls support

Just would like to confirm the max. number of parties supports in CCME v4.0 is only three regardless of the hardware platform. And how about the max. number of conference sessions at one time? Thanks.

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00806a7ff9.html#wp1063974

I'd read a post in this forum before and someone has mentioned about this CCME conferencing limitation. Thanks for the advice.

Also a bit confused about the current DSP on PVDM2 module. One url has mentioned it runs on Texas Instructment TI2510 or another one is on TIC5510.

TI 2510

http://www.cisco.com/en/US/products/hw/modules/ps3115/products_qanda_item0900aecd8016c6ad.shtml

TI C5510

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c333.shtml#dsp

Thanks again.

6 REPLIES

Re: CCME 4.0 number of conference calls support

Yes its 3 parties in a single conference. The max-conference command only sets the number of such 3 party conference that can be active at any time.

I think the PVDMs still use the 5510 chips.

New Member

Re: CCME 4.0 number of conference calls support

In order to conference more than 3 parties, you would need to use Meet-Me Conference on CME /CUE.

New Member

Re: CCME 4.0 number of conference calls support

Thanks. Bauzenne

Could you specify more on this about Meet-ME in CME/CUE? Seems like we need CUE to have more than 3 parties conference as you mentioned. Any URL will be helpful. Thanks in advance.

New Member

Re: CCME 4.0 number of conference calls support

Here is the link for Meet-Me Conferencing:

http://www.cisco.com/application/pdf/en/us/guest/products/ps4625/c1090/ccmigration_09186a0080523eaa.pdf

The document will list the requirements. Let me know if you have any questions.

New Member

Re: CCME 4.0 number of conference calls support

I guess this is IOS feature with CUE required. Thus my assumption is it will work on all 2800 series platform??

By the way, thank you for the url. It's helpful. Thx.

New Member

Re: CCME 4.0 number of conference calls support

You are correct, the 2800 series does support CUE. Meet-Me conference is a combination of IOS, DSPs, CUE, and scripts that are loaded onto the CUE. Its actually easy to configure once you have ALL the hardware / software in place.

175
Views
0
Helpful
6
Replies