Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME and CCM Intercluster trunk?

Anyone have any idea how an intercluster trunk can be setup between CCME (3.0) and a CCM cluster? I know I can use a gatekeeper to route calls between the two, but I'm trying to figure out if it can be done without a gatekeeper.

1 REPLY
Silver

Re: CCME and CCM Intercluster trunk?

ICT is not supported with CME 3.0, but is supported on CME 3.1. The link below explains how to configure ICT in CME 3.1

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123newft/123t/123t_7/cme31sa/cme31bsc.htm#wp1001000

If you have CME 3.0, on the CCM add the CME router as a H323 gateway. Use route pattern to route calls to CME. On CME use voip dial-peers to send calls to CCM.

Hope this helps!

Partha

139
Views
0
Helpful
1
Replies