Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CCME and gatekeper integration

I have branch router 1760 with CCME and trying to register with central site VOIP gatekeeper router 7200.

Under branch router config I am configuring following under each local POTS dial peer to avoid these register with gatekeeper:

dial-peer voice 150 pots

destination-pattern 8#T

port 0/1/0

forward-digits 7

no register e164

!

But for the ephone configs which appear as virtual dial-peers there is no way of appliying "no register e164" command to avoid these local ip-phone directory numbers ( actually these are branch extension mumbers) getting registered with central gatekeeper.

Is there any workaround for this issue ?

1 REPLY
Silver

Re: CCME and gatekeper integration

You can set this up in the ephone-dn using the no-reg keyword

Ex:

ephone-dn 10

number 5000 secondary 6000 no-reg [both|primary]

Depending on your setup, you can either not register both numbers or just the primary.

Regards,

Anup

111
Views
5
Helpful
1
Replies
CreatePlease to create content