Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ccme and problem with outgoing call

hello,

i use a cisco 2821 router with ccme and two double bri interfaces.the router is between a PBX and the two telecom NTBAs of the german telecom.(Anlagenanschluss)

incomming call are ok but not the outgoing calls.

look at following config and debug file

any idea ?

2 REPLIES
Silver

Re: ccme and problem with outgoing call

called number is being expanded to a full E.164 number. This won't match your sip dial-peer to go to voice mail. We can use translation paterns so that we can manipulate the number and get it to go to CUE.

voice translation-rule 1

rule 1 /^962810\(.*\)/ /\1/

voice translation-profile to_cue

translate called 1

dial-peer voice xxx voip

translation-profile outgoing to_cue

destination-pattern xxxxxxxx

session protocol sipv2

session target ipv4:x.x.x.x

dtmf-relay sip-notify

codec g711ulaw

no vad

Please add the above configuration to your CME (this dial-peer is extra to the one you already have there for voice-mail... you will need both) and try it.

New Member

Re: ccme and problem with outgoing call

The solutions was to upgrade the IOS because there was a bug.

114
Views
0
Helpful
2
Replies