Sorry about the previous post. Some small problem with posting.
CCME version 123-8.T8.
ATA v3.1.2 atah323
Fax 3 differents tested with 9600 bps
I first tried with passthrough but in this case the end of 80 % of the faxes was unreadable. So I moved to Fax mode, in this case on all the faxes there is small part missing, about 1 millimeter of half milimeter on the height, from time to time. This make the fax unreadable on this specific line.
Is it a normal situation ? I heard about quality problem with CCME + ATA + Fax.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...