I have a ccm---h323---ipipgw----sip---ccme. in other words the comunication between ccm and ccme is via ipipgw first h323 and then sip.
the direct call work fine but if the ccme ext have cwd to another ccme ext the call fail. I made a test calling direct from ccm to ccme via sip trunk and work fine. only on ipipgw with cwd fail. any ideas?
so : I made some tests: using the ipipgw on ccm like gateway only and other test using trunk. with or without mtp check. so the result is the same. I configured the ipipgw h323 to h323 and work fine but h323 to sip not working only on cwd to internal ccme ext.
direct call work fine.
un ipipgw with h323 to sip work fine only on direct call. but not on fwd. seem to be on ccme side. I actived a error debug on ccme via ccsip error:*Nov 8 01:11:16.343: //109/806226DC4200/SIP/Error/sipSPIProcessCallInfoHeader: Call-Info header with for Unsolicited Notify Absent,Disabling Unsolicited Notifies
another test was sip trunk direct ccm to ccme and work fine the fwd. only ipipgw via h323 to ccm and sip to ccme
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.