Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CCME Dial Peer selection

Hi

I have a CME3.2 in New York

I have a Callmanager4.1 in Dublin

I use this dial peer in NY for all outgoing PSTN calls. Users use 0 for a line out.

dial-peer voice 10 pots

capacity update interval 10

destination-pattern 0T

progress_ind setup enable 3

progress_ind alert enable 8

incoming called-number .

direct-inward-dial

port 0/0/0:0

This is working perfectly for incoming and outgoing calls.

I want to implement least cost routing from the CME site (New York) to a callmanager site (Dublin)

I propose using a

dial-peer voice 50 voip

destination-pattern 0011353T

voice-class codec 1

session-target ipv4:192.168.5.254 (Dublin VG)

translate-outging called 1

dtmf-relay h245-alphanumeric

no vad

translation-rule 1

rule 1 % 00

The dial peer strips out 011353 and this translation rule adds the required 00 for the VG in Dublin.

My question.

will my

dial-peer voice 50 voip

be selected first over my

dial-peer voice 10 pots

because it is a more specific match, or will my pots dial peer be selected because it is first in the list.

This is difficult for me to test as I only have VPN access to NY and I do not want to be disrupting service to the NY users

Any input is much appreciated.

4 REPLIES
Hall of Fame Super Silver

Re: CCME Dial Peer selection

The dial-peer selection is based on the closest match, so the dial-peer 50 will be selected when user dials 0011353T.

This link should help:

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml#topic7

Chris

New Member

Re: CCME Dial Peer selection

Thanks Chris,

Much appreciated

Bronze

Re: CCME Dial Peer selection

you can also use the 'show dialplan number xxxxxxx' this will detail what it matches.

Heath

New Member

Re: CCME Dial Peer selection

Thanks Heath

Very helpfull command

100
Views
4
Helpful
4
Replies
CreatePlease to create content