Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CCME - How to have multiple ring types

We are running Call Mgr Express. On the 7960 and 7940 only 2 ring types are available. On the 7912 there is only 1 ring type. How can I add more ring types?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: CCME - How to have multiple ring types

The ring tones used on the phone are stored in the TFTP path on the CallManager. A file called RingList.xml can be edited to make more that one type available to the phone. This file can found in the TFTP path on the Callmanager. You might have to use a pcm file for new tones to the ringlist file. Refer the following documents for custom phone rings.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00801ed120.html

http://www.cisco.com/en/US/products/sw/voicesw/ps4967/products_administration_guide_chapter09186a00801d196b.html#1030022

2 REPLIES
Silver

Re: CCME - How to have multiple ring types

The ring tones used on the phone are stored in the TFTP path on the CallManager. A file called RingList.xml can be edited to make more that one type available to the phone. This file can found in the TFTP path on the Callmanager. You might have to use a pcm file for new tones to the ringlist file. Refer the following documents for custom phone rings.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00801ed120.html

http://www.cisco.com/en/US/products/sw/voicesw/ps4967/products_administration_guide_chapter09186a00801d196b.html#1030022

New Member

Re: CCME - How to have multiple ring types

Thanks, I was actually asking about Call Mgr Express, not Call Mgr. I have since found the answer and it does involve creating the same RingList.xml. That file gets stored in flash on CME router, along with the ring pcm files. Also, need to add the following to the router config for each ringtype:

tftp-server flash:AreYouThere.raw

105
Views
0
Helpful
2
Replies