Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCME in a centralized design

Hello everybody....

I`m designing a CME solution but I`m so curios that it can not be deployed in a centralized design that is... a CCME on the Headquarters and only ip phones on the branch offices. I already know that the SCCP protocol doesn`t work in WAN enviroments because it doesn`t have mechanisms of QoS... the question is Why does CCM support this design? does CCM not use the SCCP?

My design is for a scenario where on the main office I have 20 users ( I`m going install a CCME) and remote offices with only 2 users. Could you help me to deploy a design with CCME?

is already Soft phone supported by CCME?

Thanks in advance!

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CCME in a centralized design

Remote phones and IP Communicator are supported with CME 4.0 now. Check this link

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00805b21ba.html#wp1056386

HTH

Sankar

PS: please remember to rate posts!

1 REPLY

Re: CCME in a centralized design

Remote phones and IP Communicator are supported with CME 4.0 now. Check this link

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00805b21ba.html#wp1056386

HTH

Sankar

PS: please remember to rate posts!

238
Views
5
Helpful
1
Replies
CreatePlease login to create content