I have a customer who has a 7912 IP Phone in the Workshop. He wants his 8 employees to each have a PIN to login into the phone before making a call.Is it possible that one can configure more than one pin number on the ephone configuration? Or is there another way to achieve this request. At the moment they are using one pin for everyone to log in.
the pin command under CME is only used for toll-bar override. So if you have restricted calls to international or LD, during hours or after hours...people can login using the LOGIN softkey and override the restriction. Again i dont think 7912 supports this softkey. You may need a a 7940 or 7960 or better to support that softkey.
Again i dont think 7912 supports this softkey-I have configured it on the 7912 and that is what the customer is using currently on the IP Phones. We are using CCME 3.3. There is a "LOGIN" softkey and is working.
Can you have more than one pin under the same ephone config?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...